Down stems are a fundamental piece of any bong. They’re the piece that ventures down into the gut of your line and gives you that immeasurably significant wind stream to channel and cool your smoke. Sadly, down stems can likewise break. Don’t bother dreading! On the off chance that you have another bong or an as of late broken more seasoned one, here’s our bit by bit guide for how to quantify a down stem to get the ideal new piece.
Stage 1: Gather Your Supplies
This step is simple — you don’t require many supplies. The main piece to have is, clearly, your bong.
Then, snatch a ruler or estimating tape. On the off chance that you don’t have both of those, get a pencil and a penny. (Attempt your sofa pads for these.) Bong down stem sizes are genuinely direct: the most widely recognized are 10mm, 14mm, and 18mm. Your pencil and coin are a critical piece of how to gauge a down stem.
Stage 2: Check Your Joint
two pennies on clear foundation
A penny is precisely 19mm in measurement. You will utilize your coin to sort out your joint size.
Begin with the female ground joint of your bong. In the event that you can scarcely get a side of the penny into the joint, it’s 10mm (or on the other hand on the off chance that you can’t slide a pencil into it). On the off chance that the penny fits in about ¼ of the way, it’s a 14mm joint. In the event that it fits about midway, it’s a 18mm joint.
Need to gauge bong down stem sizes for a male joint? Comparative estimating applies. In the event that your joint covers a little part of the penny, it’s 10mm. In the event that it covers about ¾ of the penny, it’s 14mm. Assuming that it covers practically the penny, it’s all’s 18mm.
Stage 3: Find the Length of Your Down stem
Figuring out how to quantify a down stem incorporates the length. This is where your pencil comes in.
Embed the pencil into the female ground joint of your bong so the tip drifts about ½” over the base. Preferably, it would raise a ruckus around town should the line be full. Leave an imprint on the pencil where it leaves the joint.
Presently, to quantify your bong down stem size, measure from the tip of the pencil to that imprint. Remember that down stem estimations commonly do exclude the length of the glass ground joint. These joints are normally one inch long, so you’ll need to take away that from the estimation you took from your pencil to get the ideal length.
Try not to have a ruler? Recall that pennies are 19mm wide. Count the number of pennies that fit from the tip of the pencil to your imprint and increase by 19 to get a surmised estimation (make sure to deduct 1 inch or 25 mm).
In the event that you have a 10mm joint and can’t fit a pencil inside, different choices incorporate the ink supply of a pen or you can perhaps tape a few toothpicks together when absolutely necessary.
That is all there is to it, presently you know how to quantify a down stem!
